WaveLab 7: normaliser nivåer - hvordan det fungerer
Med Wavelab kan du normalisere nivået på hele lydfiler eller seksjoner på bare noen få trinn. Vi forteller deg hvordan det fungerer.
Normaliser nivåene i Wavelab 7
Noen ganger er lydfiler for stille eller antas å ha det samme maksimale volumet for visse formål. Da må du normalisere lydfilene. Det er enkelt å gjøre i Wavelab. Du kan finne detaljerte tips i bildegalleriet:
- Åpne ønsket lydfil eller flere filer.
- I den aktive lydfilen markerer du området du vil normalisere.
- [N] -tasten fører deg til normaliseringsmenyen.
- Her kan du først la Wavelab bestemme det gjeldende toppnivået.
- I området "Ønsket toppnivå" angir du verdien du vil normalisere nivået til.
- Med et klikk på "Bruk" starter normaliseringen, det betyr at det markerte området multipliseres med faktoren som bringer toppnivået til ønsket verdi.
- Hvis du lagrer filen nå, lagres filen med det justerte nivået.
Ytterligere praktiske tips vil fortelle deg hvordan du oppretter lydmontasjer og lagrer dem som MP3.
Siste videoer
Start Wavelab og åpne ønsket lydfil via »File«, »Open« eller ved å klikke på mappesymbolet øverst til venstre.
Wavelab kan åpne en rekke lydformater, for eksempel WAV, MP3, AAC, noen av dem også fra videoformater, for eksempel AVI. Du kan se om Wavelab kan åpne ønsket format ved å dra og slippe filen til det grå området i Wavelab-vinduet.
Etter at filen er åpnet, vises bølgeformen. Merk området du vil normalisere her. Hvis du vil normalisere hele filen, velger du den med [Ctrl] + [A].
Ring via »Lydredigering«, »Normaliser nivå
«Normaliseringsmenyen. Alternativt kan du åpne den ved å trykke på [N] -tasten.
Nå kan du først bestemme gjeldende toppverdi på markeringen.
Dette normaliseres til verdien du angir i feltet "Ønsket toppnivå". Du kan normalisere til en verdi mellom -60dB og 0dB, Wavelab tilbyr ikke lavere nivåer. Med et klikk på "bruk" blir normaliseringen utført.
Hvis du vil normalisere til et visst nivå regelmessig, kan du gå inn og lagre det som forhåndsinnstilt ved å klikke på arkivskapet. Fra nå av kan du velge dette under "Forhåndsinnstilt
Load".
I motsetning til VST- eller Direct-X-effekter, er en beregning, den såkalte "rendering", ikke nødvendig. Bare lagre med [Ctrl] + [S] eller via »Fil«, »Lagre som
".